Skip to content

Boot & Shutdown Animation

The boot animation package only changes the startup and shutdown screens; it doesn’t touch the firmware. Both flash from a USB drive, but only one package per drive:

  • Animation only? The animation package alone. Firmware only? The firmware package alone.
  • Both on one drive and the flash fails — nothing installs.
  • Want both? Two passes: flash one, unplug, let the cluster restart, clear the drive, then flash the next.

Enter the password I sent you to unlock the download, then check the SHA256 against the one shown here before using it.

Customer download

This package is for customers who bought the cluster. Enter the password I sent you to unlock the download.

No password yet? Reach me from the purchase page and I will send it.

Unzip it and you get a ui_res folder with three files:

File Purpose
boot.mp4 Startup animation
shutdown.mp4 Shutdown animation
ui_res.ini Config file telling the cluster where these two videos go (replace_num=2, target path A:/media/)

Leave ui_res.ini alone. Don’t rename the folder, and don’t move the three files around inside it.

The two videos in the package were made to the spec below. Export your own to the same spec:

Parameter Spec
Resolution 1920 × 720
Frame rate 60 fps
Duration 3 seconds (180 frames)
Codec H.264
Container MP4
Pixel format yuv420p
Audio No audio track

A few notes:

  • Match the resolution, frame rate and duration. Oversized video may not play, or may stall halfway.
  • Compose for a 1920 × 720 landscape strip — not vertical, not square, or it will be stretched.
  • No audio track; the cluster doesn’t play sound.
  1. Name your two videos boot.mp4 (startup) and shutdown.mp4 (shutdown), overwriting the same-named files in the ui_res folder.
  2. Filenames must match exactly, including case and extension. boot (1).mp4, boot.MP4 and boot.mov are all ignored.
  3. Only changing startup? Replace just boot.mp4 and leave shutdown.mp4 as it is — and vice versa.
  4. Don’t touch ui_res.ini, and don’t add any other files to the ui_res folder.
  1. Unzip the downloaded archive — the archive itself can’t go on the drive.
  2. Use a FAT32 drive, 32 GB or smaller, and empty it first.
  3. Copy the whole ui_res folder to the root of the drive — nothing else on it.
  4. Engine off, ignition in the ON position (don’t start the engine), then plug the drive into the cluster’s USB port.
  5. The cluster reads and writes on its own. Unplug when it’s done.
  6. Power off and on again, and check that the startup screen has changed.
  • Startup screen unchanged: check the file is named boot.mp4, and that you copied the whole ui_res folder to the drive root rather than just the mp4 on its own.
  • No reaction when plugged in: check the drive is FAT32 and 32 GB or smaller, and try another drive.
  • Animation stutters or stops halfway: the video is over spec — re-export at 1920 × 720 / 60 fps / 3 seconds.
  • Two failures in a row: stop, and contact support.